BLHELI firmware

To unleash it's full potential, LittleBee has been designed to run BLHELI firmware. Factory flashed with BLHELI 14, it's ready for action!

Small Size

We know that with mini quads, every gram counts. LittleBee is only 24.5x12.5mm, and weights only 4g, enabling your builds to be even smaller and lighter!

Oneshot125

Oneshot125 is a different and faster communication protocol between the flight controller and the ESC on your quadcopter. It allows the FC to send control commands to the motor quicker, therefore in theory your multirotor should perform better.

Damped Light mode

This feature allows your motors to respond to throttle decreases much quicker, allowing for more stable flying, and higher response to throttle decreases.

20A 3-4s

Capable of running 3s and 4s setups, LittleBee can work with up to 20A continuous load, and 30A peak (10s).

Easy upgrades

With the BLHELI software rapidly evolving, you can flash the lastest firmware using the 3pin connector and suitable USB adapter*

Details

• Size: 24.5*12.5*3mm
• Weight: 4g with wires
• Signal Wire: 100mm
• Motor wire connector: Soldered Wire
• Signal Wire Color : White / Black
• Battery wire connector : Soldered Wire
• Motor Cable Length : 50mm
• Continuous Current: 20A
• Motor Cable Gauge : 20#
• Burst Current (10s) : 30A
• Motor Wire Color : Black
• No. of Cells (NiMh) @ 5-12NC
• Battery Wire Length : 100mm
• No. of Lipo Battery Cells : 2-4Lipo
• Battery Wire Gauge : 20#
• BEC output : None
• Battery Wire Color : Black/Red
• Programmble : Yes
• Outer Case : Clear Heat shrink
• USB link programmble : Yes
• Mosfet : All N channel
• PCB board : 4 layer blind pole board, 3 oz copper